typical_analysis_chain
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
typical_analysis_chain [2015/06/25 21:38] rashid created |
typical_analysis_chain [2015/06/26 17:30] (current) rashid |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ==== Typical analysis chain: ==== | ||
| + | |||
| + | - Raw Data. | ||
| + | The raw data, which are already converted to .slcio files, provide input for analysis run. | ||
| + | The analysis run consequently deals with a set of objects: | ||
| + | | ||
| + | 1. Pulses (obtained using pre-defined threshold and noise cuts) | ||
| + | | ||
| + | 2. Hits (group pulses together, and find centre of hit based on Pad Response Function (aka PRF) ). | ||
| + | | ||
| + | 3. Corrected Hits (time of hit is precisely calculated with some fit). | ||
| + | | ||
| + | 4. Tracks are found (hits are fed into an algorithm that groups hits together into a "track candidate"; | ||
| + | usually this will also fit the track, but the parameters are considered rough). | ||
| + | | ||
| + | 5. Tracks are fit (the hits from the track candidates are fed into an algorithm that assumes they belong to a track, and calculates the accurate parameters that correspond to that track). | ||
| + | | ||
| + | 6. Resolution is calculated (from the output of step 5). | ||
typical_analysis_chain.1435268309.txt.gz · Last modified: 2015/06/25 21:38 by rashid
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
